The first weeks after the fateful cut with a bangs
Cut your bangs in the middle only.As your bangs start to push, you must avoid having your hair in the eyes.
Once you have dried up and wearing your hair: "Take a small pair of scissors - the more it is small, the easier they will be handling - and, while holding it vertically, cut the hair that annoys your eyes" explains Cash Lawless.
"Cutting only in the center will allow the outer corners of the wick to blend with the rest of your haircut. Your hair will grow, you will end up with a perfectly symmetrical cut."
A month after cutting your wick
Separate your bangs in two. When phase 2 of the regrowth, your bangs are long enough to do something other than attach it with two small bars on the sides.
It is interesting to separate it in two to obtain a more chic effect.If you have oily skin, this technique can help you.Your forehead will tend to shine less since your wick will no longer cover it entirely.
"Before dividing your bangs dry it with a round ceramic brush" explains Lawless before adding: "The heat will completely flatten the hair and, therefore, to add a little length."
Leave your right bang since it is not long enough to make it rebuild on the sides.Then use lacquer for finish and shine.
Two months after cutting your bangs for the last time
Return the end of your wick.First, texture your wick by applying a salt water spray or a styling foam.
Then dry it but, instead of leaving your right wick as in phase 2, use a straightening iron to make the hair rebuilt away from your face.
Vidéo du jour :Do not forget to adjust the straightening iron to low temperature so that the created loop is subtle and not cardboard.Attach the cut with a fixing spray.
Three months after the cup, you are almost there!
Mix your wick to the rest of your cut.
At the time of phase 4, your wick must be much longer.To ensure that your fringe is based on the rest of your hair, slightly rebuild the ends of your face using the same ceramic brush as in phase 2.
Then use a little styling cream so that the cut is uniform.